Large dip Angle belt conveyor is suitable for large open pit mines, power plants, cement plants and ports and other applications, and has the characteristics of large transmission capacity, small energy consumption, easy maintenance and so on. In the work due to improper use or conveyor belt accident, will lead to the skirt and rubber bucket tear or fall off, replace the belt will increase the production cost. The production cost can be reduced by repairing the conveyor belt. When the conveyor belt of the large inclination belt conveyor is torn or fallen off, the following points should be paid attention to:
1. Clean up the environmental hygiene of the site, and clean up the skirt edge, adhesive surface of the rubber bucket and the surface of the belt that need to be bonded.
2. Use the polishing machine to beat and clean the belt, skirt edge and other bonding parts evenly and thinly, but the belt canvas layer or the waxing place can not appear uneven.
3, brush glue before the adhesive and agent with the harden according to a certain proportion of evenly mixed, so with the glue has fast curing, strong bonding force, heat resistance, belt expansion machine manufacturer aging resistance and bonding does not need heating, fixed pressure and other characteristics.
4, the big dip Angle belt conveyor belt brush glue coating is to be strong, thin and uniform coating, if there is a belt canvas layer or other fiber fabric layer, or beater glue off obviously, to brush more than three layers.
5. When the coating is dry and does not stick to the back of the hand, gradually press the skirt or rubber bucket onto the coating, and at the same time, beat it orderly from the middle to the edge with a hammer to eliminate the internal air.