Shrinkage belt conveyor in the actual application process will appear some failures, which will cause adverse effects on the production of enterprises, the common failures of which are analyzed, and effective solutions are put forward:
A condition in which the motor fails to start
Can check the line, repair the damaged part, detailed inspection and troubleshooting;
High motor temperature
The surface of the electric machine or surrounding debris can be cleaned up, and moderately reduce the load;
Abnormal noise of reducer
The bevel gear can be readjusted, the price of the telescopic machine or the aging and damaged parts will be adjusted and replaced, and pay attention to remove debris and dust;
Reducer temperature is too high
Should replace the lubricating oil in time, and follow the established specifications of oil injection, the coal or other debris scattered near the reducer to be removed;
Reducer leakage
Screw can be tightened, or replace the sealing ring;
Belt slip
It can clean up the water on the drum and tighten the tape again.
Tape a cardiac arrest
The brake should be checked, cleared, and the damaged bearing or roller should be replaced in time;
Overloading of tape caused multiple stops
The belt speed should be checked in time, and the bearing capacity should be appropriately reduced, or the belt speed control device should be readjusted or replaced;
Tape broken
First of all, the injury factors caused by foreign objects should be excluded, and the joint should be inspected, or reprepared, and the pre-tension force should be evaluated;
Tape running speed too low
When the belt driving motor cannot be closed, the telescopic conveyor equipment can improve the pretensioning force of the belt, adjust the belt speed device after the belt is tightened, or check or adjust the brake device;
Deviation of the tape
First of all, the cause of the accident should be investigated, and can not be adjusted at will before the cause is determined. Secondly, the deflecting belt is adjusted in the no-load operation state, the bearing section and the return section are adjusted at the unloading drum of the head, and the position of the drum is adjusted at the drum. Again, the direction of the belt is adjusted at the reversing drum to ensure that the direction of the belt is consistent with the direction of the running, and the direction of the belt adjustment at the roller should be opposite. The roller should be adjusted along one side, not both sides at the same time.